SPI Chem™ Wet Surface Replica Kit
Instructions for Use: Inspection of negative replicas
Inspection is done using a stereo zoom light microscope with optics up to 70X. While even the
best of "masters" making replicas do on occasionally end up with a small area containing a few
"bubbles", one should find areas that are devoid of such artifacts on all replicas of a series
so that when the SEM work is actually done, an area can be selected which contains no artifacts
in any replica in the series. If such an area can not be found, then we would recommend going
back and making a new set of negative replicas rather than putting good time after bad and
trying to resurrect good results from a basically bad results situation.
To Ask a Question or Make a Comment
To Place an Order or Request a Quote
Return to:
Tuesday September 30, 2008
© Copyright 1998 - 2008. By Structure Probe, Inc.
Contacting SPI Supplies and Structure Probe, Inc.
All rights reserved.
All trademarks and trade names are the property of their respective owners.
Privacy Policy
Worldwide Distributors, Representatives, and Agents
