To Ask a Question or Make a Comment
Date Effective.......... January 8, 2009
(most recent revision)
Chemical Name/Synonyms.. Triton X-100
Polyethylene glycol
octylphenol ether
Water
Emergencies
Contacting CHEMTREC:
24 Hour Emergency Use Only #'s...
Worldwide phone: 1-(703)-527-3887
Worldwide FAX: 1-(703)-741-6090
Toll-free phone: 1-(800)-424-9300 USA only
Product or Trade Name... SPI #09911-AB, 09912-AB
Synonyms................ Triton X-100 in Aqueous Solution
Polyethylene glycol octylphenol ether in Aqueous Solution
NFPA Rating:
(estimated) Health: n/a; Flammability: n/a; Reactivity: n/a
Component Name CAS # Percent EINECS/ELINCS
Triton X-100 9036-19-5 0.08-0.97% n/a
25322-68-3 0.002-0.03% n/a
Water 7732-18-5 99.02-99.9% 231-791-2
Emergency overview:
Harmful. Skin and eye irritant. Harmful if swallowed.
Risk of serious damage to eyes.
Appearance: Clear liquid.
Flash Point: >251°C (485°F) Pensky-Maartens Closed Cup ASTM D93
290°C (555°F)Cleveland Open Cup ASTM D92
Warning!
Harmful. Skin and eye irritant. Harmful if swallowed.
Risk of serious damage to eyes.
Target Organs: Eyes
Potential Health Effects
Eye: Causes severe eye irritation. Risk of serious damage to eyes.
Skin: May cause skin irritation. Possible sensitizer.
Ingestion: May cause gastro-intestinal irritation, accompanied by
nausea, vomiting and diarrhea. Harmful if swallowed.
Inhalation: May cause respiratory tract irritation.
Chronic: Possible skin sensitizer.
Eyes: Flush eyes with copious amounts of water for at least 15 minutes, holding the eyelids open. Seek medical attention. Skin: Immediately wash with plenty of soap and water. Flush skin with copious amounts of water for at least 15 minutes. If irritation develops or persists seek medical attention. Remove all contaminated clothing and wash before reuse. Ingestion: Do not induce vomiting. Wash out mouth with water, provided person is conscious. If victim is conscious and alert, give 2-4 cupfuls of milk or water. Seek medical attention. Inhalation: Remove to fresh air immediately. If not breathing, give artifical respiration. If breathing is difficult give oxygen. Seek medical attention, especially if cough or other symptoms appear. Notes to Physician: Treat symptomatically and supportively.
General Information: Wear self contained breathing apparatus MSHA/NIOSH approved or equivalent, and protective clothing to prevent contact with skin and eyes. Extinguishing Media: Water spray, CO2, Dry chemical powder, Appropriate foam. Unusual Fire and Explosive Hazards: Emits toxic Fumes under fire conditions. Foam and water spray are effective, but may cause frothing.
General Information: Wear self-contained breathing apparatus, rubber boots and heavy rubber gloves. Spills/Leaks: Absorb on sand, vermiculite, or dry lime/soda ash. Pickup, keep in closed container and hold for waste disposal. Ventilate area and wash site after material pickup is complete. Environmental Precautions: Avoid contaminating water supply. Do not allow material to enter drains or water courses.
Handling: Wash thoroughly after handling. Avoid breating vapor. Avoid contact with eyes, skin and clothing. Avoid repeated or prolonged exposure. Use with adequate ventilation. Storage: Store in tightly closed container in a cool well-ventilated area away from incompatible substances. Do not store in direct sunlight.
Engineering Controls:
Safety shower and eye wash must be available. Use with adequate ventilation.
Exposure Limits:
Chemical Name ACGIH NIOSH OSHA - Final PELs
n/a n/a n/a
OSHA Vacated PELs: n/a
Personal Protective Equipment:
Wear self-contained breathing apparatus MSHA/NIOSH approved or equivalent, and
protective clothing to prevent contact with skin and eyes.
Eyes: Chemical Splash Goggles
Skin: Wash thoroughly after handling. Wear appropriate gloves to avoid
skin contact.
Clothing: Wear protective clothing to prevent contact with skin.
Respirators: Use government approved respirator, following OSHA regulations
found in 29 CFR 1910.134 or European Standard #N149.
Engineering Controls:
Eye wash and safety shower required. Mechanical exhaust to keep below exposure
limits required.
Physical State: Liquid
Appearance: Clear to slightly hazy
Odor: aromatic
pH: 6-8
Vapor Pressure: Not available
Vapor Density: Not available
Evaporation Rate: 0.36 (Water)
Viscosity: n/a
Boiling Point: 99.9°C (water)
Freezing/Melting Point: -.01°C (water)
Autoignition Temperature: n/a
Flash Point: >230 °F
Decomposition Temperature: n/a
Explosion Limits, Lower: n/a
Upper: n/a
Solubility in water: Soluble in Water
Specific Gravity/Density: 1.07
Molecular Formula: Not applicable
Molecular Weight: Not applicable
Chemical Stability: Stable Conditions to Avoid: Exposure to light, air or water. Incompatibility with Other Materials: Strong acids, Strong bases, Oxidizing Agents Hazardous Decomposition of Products: Carbon monoxide, Carbon dioxide Hazardous Polymerization: Will not occur
RTECS#: n/a CAS#: LD50/LC50 Information: n/a Carcinogenicity: Not listed by ACGIH, IARC, NTP or CA Prop 65, Teratogenicity: Not available Reproductive Effects: Not available Neurotoxicity: Not available Mutagenicity: Not available Other Studies: Not available
Exotoxicity: Not available Environmental Fate: Not available Aquatic: Not available Atmospheric: Not available Physical: Not available
Observe all federal, state and local environmental regulations. RCRA P-Series: None listed. RCRA U-Series: None listed.
US DOT Hazard Class: Not available IATA (for international shipments): Not available
United States:
TSCA: All components of this product are on the TSCA
Inventory or are exempt from TSCA Inventory requirements.
CERCLA Section 103:
This product contains the following substances subject to CERCLA
Section 103 reporting requirements and are listed in 40 CFR Part
302.4:
Component CAS# Amount
Glycol Ethers Not available <=2.0000%
1,4-Dioxane 123-91-1 <=0.0055%
Ethylene oxide 75-21-8 <=0.0010%
SARA:
Section 302 (RQ)
None of the chemicals has an RQ.
Section 302 (TPQ)
None of the chemicals in this product has a TPQ.
SARA Codes
Delayed (Chronic) Health Hazard, Immediate (Acute) Health Hazard
Section 313
This product contains the following substances subject to the
reporting requirements of Section 313 of Title III of the
Superfund Amendments and Reauthorization Act 1986 and 40 CFR Part 372
Component CAS# Amount
Glycol Ethers Not available <=2.0000%
State (Individual states in the USA):
Component CAS# Amount
Pennsylvania Glycol Ethers Not available <=2.0000%
Massachusetts 1,4-Dioxane 123-91-1 <=0.0055%
Massachusetts Ethylene Oxide 75-21-8 <=0.0010%
California No Significant Risk Level:
California Prop. 65:
Component CAS# Amount
1,4 Dioxane 123-91-1 <=0.0055%
California SCAQMD Rule 443.1:
VOC: Vapor pressure <0.01 mmHg @20° C 0 g/L
European/International Regulations:
Existing polymer according to the definition in the 7th
Amendment to Directive 67/548/EEC and all components of this
product are on the EINECS inventory or are exempt from EINECS
inventory requirements.
Chemical Name: Octylphenoxypolyethoxyethanol nonionic surfactant
European Labeling in Accordance with EC Directives
Hazard Symbols: Xn Harmful
Risk Phrases:
R 22 Harmful if swallowed.
R 41 Risk of serious damage to eyes.
R 52 Harmful to aquatic organisms
R 53 May cause long-term adverse effects in the aquatic environment.
Safety Phrases:
S 7 Keep container tightly closed.
S 25 Avoid contact with eyes.
S 26 In case of contact with eyes, rinse immediately with plenty of
water and seek medical advice.
S 39 Wear eye/face protection.
S 45 In case of accident or if you feel unwell, seek medical advice
immediately (show label where possible)
S 60 This material and its container must be disposed of as hazardous
waste.
Canada DSL/NDSL:
Canadian Ingredient Disclosure List:
All substances contained in this product are listed on the
Canadian Domestic Substances List (DSL) or are not required to be
listed.
Disclaimer of Liability: Caution! Do not use SPI Supplies products or materials in applications involving implantation within the body; direct or indirect contact with the blood pathway; contact with bone, tissue, tissue fluid, or blood; or prolonged contact with mucous membranes. Products offered by SPI Supplies are not designed or manufactured for use in implantation in the human body or in contact with internal body fluids or tissues. SPI Supplies will not provide to customers making devices for such applications any notice, certification, or information necessary for such medical device use required by US FDA (Food and Drug Administration) regulation or any other statute. SPI Supplies and Structure Probe, Inc. make no representation, promise, express warranty or implied warranty concerning the suitability of these materials for use in implantation in the human body or in contact with internal body tissues of fluids. This product is intended for external contact only with human skin.
To Ask a Question or Make a Comment
To Place an Order or Request a Quote
