Information System
USA
Protection Association
USA
Date Effective..........October 24, 2006
(most recent revision)
Chemical Name/Synonyms..Crystalbond 555
Emergencies
Contacting CHEMTREC:
24 Hour Emergency Use Only #'s...
Worldwide phone: 1-(703)-527-3887
Worldwide FAX: 1-(703)-741-6090
Toll-free phone: 1-(800)-424-9300 USA only
Product or Trade Name.. SPI #05111-AB, 05111-BA Crystalbond 555
| Hazardous
Material Information System USA | Health | 0 | National Fire Protection Association USA | |
| Fire Hazard | 0 | |||
| Reactivity | 0 | |||
| Personal Protection |
Component Name CAS # EINECS/ELINCS Ethylene Oxide 75-21-8 200-849-9 Ethoxylated Nonyl Phenol 9016-45-9 n/a
Appearance: Off-white solid Flash Point: >200°F Potential Health Effects Eye: Not applicable. Skin: In molten state this material may cause a severe thermal burn. Ingestion: Not applicable. Inhalation: There are no known data available which addresses medical conditions that are generally recognized as being aggravated by exposure to this product.
Eyes: Flush with copious amounts of water for 15 minutes. If irritation occurs, seek medical attention. Skin: Treat for thermal burn. Seek medical attention. Ingestion: Not applicable. Inhalation: Not applicable.
General Information:
There are no unusual fire and explosion hazards and no special fire fighting
procedures required.
Extinguishing Media:
Foam, Carbon dioxide, Dry powder.
Flash Point: >210°F (Closed cup)
Explosion Limits:
Upper: n/a
Lower: n/a
Autoignition Temperature: n/a
Spills/Leaks: If material is unusable, sweep up and dispose of in a metal container. Provide adequate ventilation. Dispose of in accordance with all federal, state and local regulations.
Handling: Use adequate ventilation. Avoid excessive heat, sparks and open flames. Storage: Store in cool dry place. Keep containers tightly closed.
Exposure Limits: Chemical Name CAS# ACGIH TLV OSHA-Final PELs Ethylene Oxide 5-21-8 n/a 1 ppm Ethoxylated Nonyl Phenol 9016-45-9 n/a n/a Personal Protective Equipment Provide adequate ventilation to keep exposure limits below the recommended TLV. Where this is not possible, personal respiratory protection should be employed. Eyes: Safety glasses recommended. Skin: Protect from thermal burn in molten state.
Physical State: solid
Appearance: off-white
Odor: n/a
pH: n/a
Vapor Pressure: n/a
Vapor Density: 1.0 (air=1)
Evaporation Rate: nil
Viscosity: n/a
Boiling Point: >200°F
Freezing/Melting Point: 110°F
Autoignition Temperature: n/a
Flash Point: >210°F (Closed Cup)
Decomposition Temperature: n/a
Explosion Limits:
Lower: n/a
Upper: n/a
Solubility in water: 100%
Specific Gravity/Density: 1.12
Molecular Formula: n/a
Molecular Weight: n/a
Chemical Stability: Stable Conditions to Avoid: Excessive heat, Sparks, Open flames Hazardous Decomposition of Products: Carbon monoxide, Carbon dioxide Hazardous Polymerization: Will not occur
There is no known data available which addresses medical conditions that are recognized as being aggravated by exposure to this product.
No data available.
Dispose of in accordance with all federal, state and local regulations.
US DOT Hazard Class: Not hazardous from standpoint of transportation. IATA (for international shipments) Not hazardous from standpoint of transportation.
United States: TSCA All components of this product are listed on the TSCA Inventory. SARA Chemical components of this product which are present in reportable quantities and are listed in Section 313 of the Emergency Planning and Community Right to Know Act of 1986 (SARA Title III) are shown below with their CAS Registry Numbers and Maximum Composition by weight. Listed Chemical CAS# Maximum Weight % none Canada CAS# 75-21-8 is listed on the DSL List. CAS# 75-21-8 is not listed on the NDSL List. CAS# 9016-45-9 is listed on the DSL List. CAS# 9016-45-9 is not listed on the NDSL List. WHMIS: This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations and contains all the information required by the CPR. European: Safety Phrases: S25 Avoid contact with eyes. NOTE: n/a = not available
Disclaimer of Liability: Caution! Do not use SPI Supplies products or materials in applications involving implantation within the body; direct or indirect contact with the blood pathway; contact with bone, tissue, tissue fluid, or blood; or prolonged contact with mucous membranes. Products offered by SPI Supplies are not designed or manufactured for use in implantation in the human body or in contact with internal body fluids or tissues. SPI Supplies will not provide to customers making devices for such applications any notice, certification, or information necessary for such medical device use required by US FDA (Food and Drug Administration) regulation or any other statute. SPI Supplies and Structure Probe, Inc. make no representation, promise, express warranty or implied warranty concerning the suitability of these materials for use in implantation in the human body or in contact with internal body tissues of fluids. This product is intended for external contact only with human skin.
To Ask a Question or Make a Comment
To Place an Order or Request a Quote
