SPI Supplies
SPI Supplies Division
Structure Probe, Inc.

P.O. Box 656 West Chester, PA 19381-0656 USA
Phone: 1-(610)-436-5400 Fax: 1-(610)-436-5755
E-mail: spi3spi@2spi.com

WWW: http://www.2spi.com
Manufacturer's CAGE: 1P573

Material Safety Data Sheet

SPI #04088-AB Cargille Gem Refractometer Liquid


Section 1: Identification

Date Effective...........  January 8, 2009
                     (most recent revision)
                     
The information supplied is based on data available to us and is believed to
be correct.  However, no guarantee or warranty of any kind, expressed or
implied, is made with respect to the information presented and neither
Cargille Laboratories or SPI Supplies assume no responsibility for the
results of the use of this product.  This information is furnished upon the
condition that the person responsible for its use shall make their own
determination of the suitability of the material for their particular
application.


Chemical Name/Synonyms...  Not known



Chemical family..........  Not available

Emergencies
Contacting CHEMTREC:

24 Hour Emergency Use Only #'s......
Worldwide phone: 1-(703)-527-3887
Worldwide FAX:   1-(703)-741-6090 
Toll-free phone: 1-(800)-424-9300 USA only


Product or Trade Name....  SPI #04088-AB Cargille Gem Refractometer Liquid


CAS #....................  Not known

Chemical Formula.........  Not known



Section 2 Composition

Component Name CAS #   OSHA  OSHA  ACGIH ACGIH Carcinogenic 
                        PEL  STEL   TLV   STEL   TWA
                        
Diiodomethane (methylene iodide)      25 ppm

Proprietary additives   N/L   N/L   N/L    N/L     N/L

             Note:  N/L = Not listed

Concentration by
                  Wt/Mol%     Avg.   Min.     Max.
                          Not known
                          
Note:  PEL ceilings & TLV TWA's if any should not
occur if C. I. U. and sections 7 and 8 are followed.


Note:  Product is sold in 10g and 4 oz quantities and
is used either as a single drop to a few ml per application.




Section 3: Hazard Identification


Emergency overview:

       This material is not hazardous by OSHA Hazard Communication 
       Definition

Signal Word

       CAUTION!


Physical Health Hazards:

       None known

Physical state:   Liquid

Color:            Burgundy

Odor:             Slight characteristic odor


Odor threshold:   No data available




Potential Health Effects:

Routes of exposure

           Eye contact, ingestion, skin contact

Skin contact:

           No data available

Inhalation:

           No data available



Eye contact:

           No data available

Ingestion:

           Ingestion is unlikely

Chronic Health Effects Summary:

           No known chronic health effects.


Conditions Aggravated by Exposure:

           No known conditions are aggravated by this material.


Section 4: First Aid Measures


Inhalation:  If symptoms are experienced, move victim to fresh
             air, if symptoms persist, obtain medical attention.

Eye Contact:  Wash eyes with clean low-pressure water for at
least fifteen minutes.  Contact a physician in any case, preferably an
eye specialist.


Skin Contact:  Wash affected area with soap and water.



Ingestion:     Wash out of mouth, consult physician immediately.




Section 5: Fire Fighting Measures

NFPA Rating:  Not known

Flammability classification:

         Not flammable.


Flash Point/Method:   > 110°C (230°F) / Cleveland Open Cup (COC)



Auto-Ignition Temperature:  Not known

Flammable Limits:  Lower:   Not available
                   Upper:   Not available

Hazardous Combustion Products:

         Not known at this time.

Special Conditions to Avoid:

         Not known

Extinguishing Media:

         Treat as petroleum grease/oil fire.  Use CO2, foams, water spray

Fire Fighting Instructions:

          Protective Equipment/Clothing:  Wear a NIOSH approved positive
          pressure self-contained breathing apparatus and firefighter
          turnout gear.

         Instructions:   Use flooding quantities of water until well after
         fire is out.  Avoid fumes which may contain iodine.
         



Section 6: Accidental Release Measures


Release response:

              Pick up and retain for recycle or disposal.  Do not flush
              spilled material to the sewer or the environment.

Reportable Quantities:  See Section 15: Regulatory information.



Section 7: Handling and Storage


Respirator:  Not necessary

Ventilation:
                  Local:  Recommended (Hood with 80-100 FPM)
                  Mechanical:  5 air changes / hour.


Skin:  Surgical type gloves mandatory


Eyes:  Wear approved eye protection when working with any laboratory
       chemicals or reagents.




Section 8: Exposure Controls and Personal Protection


Engineering Controls:  None specified

Personal Protection:

    Eyes:  Always use approved safety glasses.
    





Section 9: Physical and Chemical Properties


Appearance and color: Burgundy liquid

Boiling Point at 760 mm Hg:  181° C (358° F)



pH:                   Not applicable


Vapor Pressure:       760 mm Hg @ 23° C/73° F.... 1.5



Viscosity:            Not applicable

Specific Gravity (water = 1) @ 23° C/73° F:  3.14


Water solubility:     Slight
Octanol/Water Partition Coefficient in Kow:   Specific value not known

Melting/Freezing Point:  < 20°C (68°f)

Evaporation Rate (mineral oil = 1, 760 mm Hg, 73° F/23° C):  1




Section 10: Stability and Reactivity


Chemical Stability:   The product is stable

Conditions to Avoid:  Heat above 150° F

Incompatibility with: Strong oxidizing agents.

Hazardous Polymerization:  Will not occur



Reactions with Air and Water:  Does not react with air, water or other
common materials.




Section 11: Toxicological Information


Effects of over exposure:
      Ingestion:     Wash out mouth and contact physician immediately.
      Inhalation:    May cause headache and nausea
      Skin contact:  Not known under conditions of intended use.
      Eye contact:   Not known under conditions of intended use.

Carcinogenicity:
      Not carcinogenic (No IARC monographs)



Threshold Limit Value:
      AGCIH TLV:     TWA:
           Not known

      OSHA PEL Ceiling:
           Not known

Chronic Effects/Carcinogenicity:

          None expected

Reproductive/Development Effects:
          Not known.




Section 12: Ecological Information


Exotoxicity:  Exotoxicity is expected to be low based on the low water
solubility of this material.

Environmental Fate:  No information found in our selected references.


Bioaccumulation:  Not expected to occur.



Section 13: Disposal Considerations


This material is NOT classified as a hazardous material by RCRA.  Use only
licensed transporters and permitted disposal facilities and conform to all
laws.




Section 14: Transport Information

 

Proper Shipping Name:  Not specified


DOT Hazard Class:      Non-Regulated

UN/NA ID:              Not Regulated


Packing Group:         Not Applicable


Labels:                Not Regulated

Marine Pollutant:      No

NAER Guidebook:        Not Regulated


DOT Status:            Not Regulated



Section 15: Regulatory Information


TSCA:  All components of this product are listed on the TSCA 8(b)
inventory.  If identified components of this product are listed under
the TSCA 12(b) Export Notification Rule, they will be listed below.

    TSCA 12(b) Component      Listed under TSCA Section


SARA-Section 313 Emissions Reporting:

    Component                  Reporting Threshold

SARA-Section 311/312:  No components present in this product are
subject to the reporting requirements of this statute.

CERCLA Hazardous Substances and their Reportable Quantities: 

    Component                  Reportable Quantity



California Prop. 65:
Proposition 65 requires manufacturers or distributors of consumer products
into the State of California to provide a warning statement if the product
contains ingredients for which the State has found to cause cancer, birth
defects or other reproductive harm.  If this product contains an ingredient
listed by the State of California to cause cancer or reproductive toxicity,
it will be listed below:




Section 16: Other Information


Disclaimer of Liability:

Caution!  Do not use SPI Supplies products or materials in applications
involving implantation within the body; direct or indirect contact with
the blood pathway; contact with bone, tissue, tissue fluid, or blood; or
prolonged contact with mucous membranes.  Products offered by SPI Supplies
are not designed or manufactured for use in implantation in the human body
or in contact with internal body fluids or tissues.  SPI Supplies will not
provide to customers making devices for such applications any notice,
certification, or information necessary for such medical device use required
by US FDA (Food and Drug Administration) regulation or any other statute.
SPI Supplies and Structure Probe, Inc. make no representation, promise,
express warranty or implied warranty concerning the suitability of these
materials for use in implantation in the human body or in contact with
internal body tissues of fluids.

************************************************************************

The information and recommendations set forth above are taken from sources believed to be accurate as of the date hereof, however SPI Supplies and Structure Probe, Inc. make no warranty with respect to the accuracy of the information or the suitability of the recommendations, and assume no liability to any user thereof. The information contained in this sheet does not constitute a hazard assessment and should not be used in place of the user's own assessment of work place risks as required by other health and safety legislation.


To Ask a Question or Make a Comment

To Place an Order or Request a Quote


Return to:
Monday March 22, 2010
© Copyright 2010. By Structure Probe, Inc.
Contacting SPI Supplies and Structure Probe, Inc.
All rights reserved.
All trademarks and trade names are the property of their respective owners.
Privacy Policy

Worldwide Distributors, Representatives, and Agents Flag logo